NanoMoto

Assemble Instructions:

Remove the protective paper from the acrylic, note that the photos still have it on.

Robot_1

Attach the bolts onto the hex risers, but leave them slightly loose.

Robot_2

Push one motor mount through the hole, line the other up and lock into place. Fasten the bolts ensuring that the nuts are on in inside.

Robot_3

Repeat for the other side. Line the caster wheel up and secure with nuts. Tighten the bolts too.

Robot_4

Attach the wheels by gentle wiggling them on, make sure to line the key up on the shaft.

Robot_5

Tape or cable tie the battery pack in place, attach the breadboard on the front leaving enough room for the battery connector.

Robot_6

Insert the Arduino Nano as shown, Upload the test sketch and your robot should be move.